stuck on step 5 programming

Question

my car is chevy cruze diesel 2015 pts after market. it origin of thailand. I did connected the evo-all's wire to car BCM as overall wires and plugs all most same to the instruction guide. the problem is the evo-all seem to stucking at step 5 the red and yellow are blinking after push 1x pts. kindly help or advise how to make it complet. thanks

Answer 1

Unit options look corrupt: http://fortin.ca/en/support/001A06673175/

 

Try a reset first.  http://wirecolor.com/en/qa/50193/faq-how-do-i-reset-my-evo-all?show=50193#q50193

The only options you need for remote start are; A1 to A11, C1, D1, D2, D6 (and whichever one of the H options if you are using an rf-kit)

Comments

I did follow your instruction the problem still there. the red & yellow LED blinking after push the PTS.  I have checked the wiring are corrected and proper connect.

How to looking more or any advise.

Thanks