Questions & Answers

Remote start doesn’t do anything

0 votes
I have a 2017 Mitsubishi Mirage Hatchback manual transmission with the standard key. I have an Evo-One installed according to the wiring diagram listed on this site. After a firmware update was performed on the bypass, I updated the firmware on the remote start portion of the unit. I then programmed it into the vehicle, went back to the computer and sent the information through to generate a key code. I reinstalled the unit in the car and when performing a remote start, nothing happens. The vehicle only reacts as if the car was not equipped with an additional device. I only hooked up the wires as shown in the install guide, nothing additional. Should I have hooked up others? Please help. Thanks.
asked May 7, 2019 in Mitsubishi by Tim Vanderwouden (180 points)

1 Answer

+1 vote
 
Best answer
The car is not 3x lock compatible, a seperate RFKIT is required.
answered May 7, 2019 by Mathieu Bertrand Collin (62,040 points)
selected May 7, 2019 by derek g

Related questions

...