2004 Durango...Ignition turns on but no crank

Question

I just installed an EVO-ONE using the THAR-CHR5 harness per Guide #16671 (which BTW is missing telling you to cut the yellow loop for an automatic).  Everything appeared to program correctly and when I press the Lock button on the fob 3x I can see the blue light flash, then the red one comes on and Ignition comes up and the fuel pump primes, but it does not crank at all.

Now I suspect the issue may be linked to the fact that I do not have the front doors installed at this time, so I think the unit is seeing the doors as open (and it'd be right).  

Also, I have not installed the hood pin yet so the wire is currently floating.

Any suggestions?

Thank!

Answer 1

Verify that there is power comming out of the starter wire on the evo (yellow E6).

Also what is the service number to the unit?

Comments

It was the doors.  I jumpered the two door latch wires on the connectors on both sides and it fired right up.

To answer your question about the service number, it is 002B07 337376

Thanks,