Questions & Answers

Spark 2017 key

0 votes

I have a 2017 Spark key.

I connected the Wire to Wire as per the instructions.

https://cdn02.fortin.ca/download/90461/EVO-ALL_IG_SAL_BI_CHEVROLET-SPARK_2016-2019_A_90461.pdf

When I press the key 3 times lock the switch will open but don't start and the light flashed 3 times red.

When running the engine and shutdown by using the key and pull out then  i press the lock 3 times the vehicle runing! and i can put the key in and drive, but if I press the brake the engine stop and I cannot start again from the remote (If i try the switch will open but will not try to start) I must use the key again to start and stop the engine and pull out to I can start again by using the lock button with someone below firmware version!.

Sometimes the engine starts and stop immediately.

I tried firmware version  70.46 & 70.41 & 70.42 & 70.43 & 70.44

I want to reset both units

SN: 001A07157086

SN: 001A07501809

posté depuis 1 jour dans la catégorie Chevrolet par MUSTAFA ADNAN (870 points)

1 Réponse

0 votes
Hello,

Did you connect the lt.blue wire on the 20 pin connector the the lt.blue/black?

If not then please connect them and re test.

Best regards.
répondu depuis 7 heures par derek g (363,980 points)

A10/A20 alright connected to each other and connected with Gray/Black

What about D4/A9 Do I connect them together and connect them with D6

What about the firmware version? Should I go with 70.41?

 What about reset both units?

SN: 001A07157086

SN: 001A07501809

"What about D4/A9 Do I connect them together"

- Yes

"and connect them with D6"

- No, D4/A9 go to one side of the wire you cut in half, D6 goes to the other side of the wire you cut.

Fw 70.46 is fine for this vehicle.

The flash limit has been reset.
...