Hi I have an Evo All updated to the lastest firmware as of today (12/11/2020) 79.65 I believe, with all preset options, meaning i did not turn on or off any feature on the Evo All through the FlashLink Manager. To pair with the Evo All I have an Encore E1.
My vehicle is a 2015 Toyota Corolla L H-KEY without smart key (no lock or unluck button on it)
Evo All Installation Guide with Remote Start Unit
Encore E1 Installation Manual.
So I have all the Evo All cables connected to the car which are
A20 to 30-pin connector position 16;
A18 to E3 White 40-pin connector position 34;
A10, C3, and C4 to OBD-II connector in its respective positions 7, 6, 14;
Also I have the Encore E1 connecting to the Evo All which are
10 Pin Encore E1 connector -> 20 Pin Evo All connector
White/Red Tachometer -> A12
White/Black Hood Pin -> A15
Black/White Brake Shutdown -> A11
White Ground when Runing bypass output -> A8
Pink Security Disarm Signal -> this is connected to Lt. Green wire in the Driver Kick white connector.
So its missing couple wires to be wireout such as:
Encore E1 10 pin connector
White/Blue Instant Start Input (+) -> which i have no idea what is the purpose of this wire and where to connect.
Gray Channel 3 Trunk Output -> i didnt do it because i dont have a eletronic trunk release, mine is manual pull up type.
Blue/Black ACC2 -> because my vehicle doesnt have a second ACC
Yellow Ignition 3 output -> again because the car doesnt have it.
So, to summarize, the vehicle locks and unlock just as it should through the Encore E1 4-Button remote control, however, the remote start function will turn on the car in the first try but it will only stay on for 5 seconds, then it shut itself off. After, it tries to start it again, and the cycle repeats 1 more time after that, totaling 3 tries. It starts but wont keep on after 5 seconds.
What am i doing wrong? what am i missing here?
I have no idea whats missing or why this is happening. If someone has an idea, please share with me. Thank you so much.