2004 Honda Accord - evo-all installation question

Question

Hello, Fortin support!

I'm planning to install an Evo-All module into a 2004 Honda Accord, and using Connection 1 per manual (page 5), http://fortin.ca/download/15731/evo-all_honda_acura.rev-20140509.pdf

I am confused, because White/Red and White/Green wires of 6-pin Red connector, both say "Relay 2" (Please, see attached picture).

Should each of these wires be wired thru a separate relay? If so, how should it be done?

Please, advice.

Thank you

Answer 1

Ignore the RELAY 2 tag. It just means it will be connected to the internal relay of the EVO. Put liquid paper on it :)

Comments

Thank you, as usual!