Questions & Answers

2015 sedona won't program evo-all

+1 vote
i installed autostart with evo-all

i used D2D and program perfect but door lock,unlock is not working and not detected hood pin,door status,brake

s/w

i rechecked can bus high,can bus low wires one side 5v,other side approx 0v

so tried connect opposite side,but won't program

also tried the other brand bypass module(idata) but no change

i working at kia so i look at ours manual. 100% correctly connected CAN high and,low lines

what i need to check now?
asked Mar 13, 2015 in Kia by pilmooon jung (200 points)
retagged Mar 13, 2015 by Robert T

1 Answer

0 votes
1- Can wires are typically 2.5V each with ignition on. Having 5V and 0V is like if the vehicle had a fault somewhere and now swapped to single wire can-bus instead of using dual wire can-bus. This is why you are having trouble with both the idata and fortin module. That can network needs to be reset somehow and you need to follow the dealer procedure for Can-bus diagnostic.

 
2- D2D with autostart you need to enable option F3 in the evo-all and then set the autostart to expresskit.
answered Mar 13, 2015 by Robert T (297,620 points)
1. tried the other can line but no change. also one side voltage 0 to 1.5v moving

so my tester said 0v

scan for all systems no codes found.

factory fob and door panel door lock s/w is working good

looks everything is normal but it's not working

2. i did already and rechecked

i have been installed two 2015 sedona already

this is third times. i could not understand. what is problem.

You might need to test the Can Bus resistance, in your service guide should be a step by step guide on testing the resistance on the Can Bus system, it will require you to power down the vehicle and the test the resistance on the can wires. This will tell you if there is a open connection or short in the system

IF the PDI is not finalized on the vehicle, not all can-bus features will work
...