2006 Dodge Ram evo-chrt5 turns ignition to run but won't start.

Question

Service no 003606 001496. I made all the connections and followed the program procedures. When I push the lock on keys 3x the truck will unlock then lock the leds will flash on eco all then the ignition will turn on but it won't start the truck. I can hear fuel pump prime but it doesn't turn truck over. I didn't use a resistor in the parking light wire tap but I had read that it only triggers lights and doesn't effect the remote start itself. Is this a programming problem? Or maybe software? I'm using and connecting thar-chr5 harness with out the data link like wire diagram c shows. I have the omevoall can bus interface module

Answer 1

Did you cut the yellow/red wire on the T harness connector and connect it to the starter wire at the ignition cylinder?

Comments

I got through to your tech support and they informed me I had to use wire diagram f. Which I did and it is still doing the same thing. Turns on ignition but doesn't turn over truck. I did connect the yellow/red to ignition. I also connected the white/blue to battery, white/red to starter. As well as the green/red to mux. Still I get the same turn out. Truck now has check engine light on. Code P0403. It's the egr which I think the code has nothing to do with the evoall. Does the evoall keep truck from starting when check engine light is on?