Questions & Answers

2018 Tundra 3x oem key remote start

0 votes
Service# 002B07 121019

Guide followed #69709

2018 Tundra H-key folllowed exactly as it showed on the guide,module programmed properly, when remote starting 3x lock truck will start but  shuts off instantly, second attempt will only crank for 6-8 seconds but not start.then when using physical key it will just crank but not start,ill have to wait about 5minutes before i can start the truck normally with the key, please need help,thank you.
asked Apr 5, 2020 in Toyota by Edrice Iraola (1,090 points)

2 Answers

0 votes
option 2.4 is not enabled and it should be. This option is properly configure the igniiton/starter outputs of the unit for that vehicle.
answered Apr 6, 2020 by Robert T (297,620 points)
Hi Robb thanks for replying, I went ahead turned on option 2.4 then re program module but it's still doing the same thing.,any other suggestions?is there any other wires that needs to be connected other than the one on the guide?thank again and be safe out there!!!
Please still need help on this issue,thanks
Please I really need help to figure this out thank you
0 votes
Did you fix the problem? Cuz Imma install it on 2019 tundra, and i am also wondering, if evo all supports 3xlock oem remote start ?
answered Apr 12, 2020 by chanh nguyen (340 points)
No I did not,3x lock start  works but the truck shuts down right away then on 2nd attempt it will crank but won't start ,that's what I'm trying to solve., hopefully soon.
did you use EVO ONE or EVO ALL ? and did you use t-harness or you manually wired the harness?
Evo-one & no T-harness,I hard wire it.
Just wanna update,on the 6pin connector I followed 2017 connection for the 6pin instead of 2018 one. The only difference is the orange and white wire connections between 2018 & 2017 tundra.. instead of connecting the white wire I used the orange wire..and everything works perfectly!!!
...