Questions & Answers

Can't get programming sequence to go through Evo GMT1, used to work

+1 vote
2011 Chevy Camaro SS.

During the first programming section, I can not get the yellow light to flash constantly during the second key sequence.

Okay, try the second programming section. Second key squence, sometimes the yellow doesn't flash, and I have never seen the blue flash. I unplugged it anyways, ran it through decrypter. It says it decrypted.

Remote start still won't work.

I had a helluva time getting it programmed the first time early last year. In fact, I gave up on it and then it decided to start working. I left it out so I could see the lights. It quit working again and now won't program.

Checked fuse F1 which says it's for the "Discrete Logic Ignition Switch", it's fine.
asked Feb 2, 2016 in Chevrolet by Brett Smith (250 points)

1 Answer

0 votes
 
Best answer
If blue never flashed then it never learned the can bus. Try doing the following.

1-Insert the 4 pin connector while holding the program button.

2-Release the button on the BLUE led.

3-Insert all other connectors.

4- Turn ignition on ( the blue led should go out and then flash rapidly)

5- Turn ignition off and remove key. ( blue led should turn off)

At this point try and remote start the vehicle with 3x lock on oem remote. The blue led should flash with every lock press on your oem remote.
answered Feb 2, 2016 by derek g (339,670 points)
selected Feb 6, 2016 by Brett Smith
Was a loose connection on the green wire that goes to the brown wire.

Thanks!
...