Car starts then stalls and dash says No Key

Question

Installed and programed Evo-All in a 2011 VW Jetta with standard key.  I am using the TB-VW bypass and when pressing the remote 3 times, the car starts, but then immediately stalls.  NO KEY is diplayed on the dash panel.  The decryptor process seemed to work OK.  Any help would be appreciated.

Answer 1

Please tell us how the red led flashes when you initiate remote starting.

 

Thank you,

Comments

The red led stays lit steady as does the amber led.

---

The red led should flash rapidly for about half a second after initiating remote starting BEFORE the yellow turns on, this is when the evo-all is communicating with the TB-VW, please make sure the tb-vw is well plugged in. Please post the date on the bottom of the TB-VW

 

Thank you,

---

The date is 11/2017

---

Are you using a t-harness for the installation? If not, you will need to check the 12v, ground and the 2 data wires from the TB-VW, from what you are describing it would seem that the evo is not able to communicate with the TB-VW which is why the key codes are not being sent.

 

 

Thank you,

---

I am using a t-harness.  Is there a way to test the TB-VW?  If I disconnect the TB-VW, the car will start with the key, but then immediately stall and NO KEY will be displayed on the dashboard, leaving me to believe that the TB-VW is doing it's job.

 

Thank you

---

Did you ever solve this issue. I'm having the same problem on my 2012 beetle.