HEADLIGHTS FLASHING when entering vehicle AFTER 3xstart and 15min run time is met

Question

2016 kia sedona ex push to start

t-harness

When entering the vehicle after using 3xstart and 15 min run time ends- OR starting using push to start button- the vehicle is flashing headlights/tails only. Vehicle will start- but the headlight indicator on insturment cluster lights in unison with the headlights/tails. The vehicle will start and have no flashing lights using the 3x press on remote.

Is there a toggle that is active that should not be?

I am current on software version. I did need to toggle 3x press on so the vehcle would use remote - folliwin the installation instructions .

Answer 1

What is the 12 digit service number (s/n) of the module?

At step 5 programming, while the BLUE LED is flashing, is the RED LED on solid?

Comments

I will look- vehicle is in owner possesion. I am at another job until 4pm.

As I recall the blue light flashed but red was NOT on solid- flashed rapidly 6 or 10 times and then blue comm light was flashing and done.

---

UPDATE-

T harness THAR-ONE-KHY8 was used for install

Step 5 DID have red lamp rapid flash , followed by blue flash- , then one push of the push-to-start to turn off vehicle.

3x remote lock functioned normally.

The hood pin feature is NOT installed- and the toggle A11 was turned to off.

Valet button is also NOT installed.

 

Vehicle operates correctly

---

12 digit is 002B0222908

---

Turn 14.1 on instead of 14.2 and see if the light flash persists