2010 focus wont remote start

Question

2010 focus, uses key fob seperate from actual key.  t harness connected, using the correct can high low (reversed to test, did not even program) connected yellow light blue and light blue black from 20 pin to t harness same colors. seems to allow programing once i did that. When i try the first step the blue light is on...turn key...light goes off for a few seconds, blinks blue for a few seconds then turns yellow.(i have a feeling thats not right. stays yellow until i turn off. i do the red programming next with two master keys. after second time i press and hold prog. button red light blinks 10 times,  and car stays in "on" position. it does not turn off with brake pedal or by removing the key, its like its overriding the system to stay on without the key. thats closest ive gotten to anything to work. any other programming does nothing at all. i press lock 3 times, blue light blinks but no attempt to start. please help/

Answer 1

First the options for 3x lock does not look to be enable in your module.

 

For programming, the ignition going on is actually a new feature and guide might not be updates. When it power up the red led should flash 10x times. Does it flash ?

Comments

ignition going on is a new feature? does that mean i have to flash the module to enable remote start? when i turn the car on only the yellow led is on if thats what you mean. the only time i can get the red to flash 10x is on the third programming step, first is blue. then the red with the two keys. then the step where you hold the program for 5 seconds and the red led flashes. it does it all that. but i press the lock button three times after and nothing happens.

---

You module looked to have programmed successfully. For 3x lock to work you actually have to enable the option inside the module and that's done with the flashlink manager and a computer.