Correct ignition wire, pin number on what plug letter located on BCM passenger kick panel?

Question

2016 Dodge Charger SE
EVO-All Ver.6 Firmware 74.32 with CHART6 harness

I have verified connection back to the EVO with meter. Ignition wire is one I am uncertain of. On the BCM I have metered every wire from harness A to G, I get 12V on both "pink/white" from BCM connector E.
When using either of the pink/white wires the car will turn over but die, or start n run less than 2 seconds, or till the EVO clicks again killing engine.

Please help, I planned to have this ready for Christmas.
Thank you,
Bill

Answer 1

I don't think your looking at the right spot. It says passenger side kick panel which would be below the BCM. More confusing they have the number 3 symbol on the driver side kick panel. Maybe that will help.

Comments

Thanks Anthony,

So does the A1 wire from 20pin EVO-ALL need to go to harness on the driver side, near OBD-II connector where symbol 3 shows?

---

I am not sure, but it's saying passenger side and showing driver side. I would try passenger side but that's just a guess. It will be the panels in the feet well where the side of your feet can hit.