EVO-ALL-RS-FV6 for Vw Tiguan 2011

Question

Hi. I bought this EVO-ALL-RS-FV6 for 07-2010 Tiguan. I installed it. Firmware 75-41. Hardware 7. I installed the options. The first time when programming the key decryptor, I pressed and held the module button, the LED blinked, everything was correct, it saved the keys. I connected the module to the flasher and it transmitted the decrypt to the server, the server calculated and returned everything back and stitched it into the module. I disconnected the module from the flasher and connected it to the car according to the instructions. And nothing. The LED on the module is always red, does not react to anything. I tried to do a reset, according to the instructions, holding the button, connect the power supply and release it when it lights up red, then press and hold until the LED starts blinking, release the button and turn off the power .... nothing blinks, it just lights up red all the time. I tried to reflash the module with a flasher, it reflashed, now there is the 2nd entry out of 8. How to revive the module?

With best regards

Answer 1

Hello,

Here is how to correct the red led issue: https://www.wirecolor.com/en/qa/92073/faq-red-led-stuck-on?show=92073#q92073

Once that is done, master reset the evo: https://cdn.fortin.ca/en/download/61931/61931.pdf

From there set options/firmware for vehicle being worked on and re program it in the vehicle.

 

If you need the flash count reset simply provide the S/N module and i can reset it for you.

Best regards.

Comments

Hello. Thank you, I did a reset. But in the process of searching for the problem by blinking the LED 5 times. The number of decrypts was exceeded, the decrypt was blocked. , the number of programmings remained 4. My number is 001 A07 559 607. And I still have not decided why, after decrypting and writing to the module, I connect the module to the car, red and yellow are on, I turn on the ignition and the LED blinks red 5 times ...

---

I have re submitted your module for reset.

It will be ready for use within 24 hours.

 

Please program the module to the car 1x, if it does not work stop and call trechnical support before locking it up again: 1-877-336-7797, mon-fri, 8am 6 pm est.

 

Best regards.

---

Thanks for extending the decryptor, but everything remains the same. According to the description of p. 13, after connecting to the car, red and yellow light up. p. 14 - Turn on the ignition, both go out and the red light comes on and then starts blinking 5 times, a pause and again, the same even after turning off the ignition p. 15. The blinking occurs endlessly. If you reconnect the connectors again, then everything happens again with p. 13. I am confused by the alternating blinking of yellow and red in p. 8. It says that the alternating blinking is slow. What does slow mean? I have about 2-4 times per second, is this normal?

---

5x red flash after the first dcryptor is the error code for the first dcryptor haivng not worked. This only normally happens on vehicles outside of the north american market.

Where are you and this vehicle located? If it is outside of Canada or United States, strong chance your gonna have to sacrifice a key for remote start as the tb-vw solution will not work.

Key required installation guide: https://cdn02.fortin.ca/download/92501/EVO-ALL_IG_RTS_BI_VW_TIGUAN_2010_KEY_C_92501.pdf

 

Best regards.